Inspection |
1. |
Connect the KDS/GDS on the Data Link Connector (DLC). |
2. |
Measure the output voltage of the MAPS during idle with IG ON.
|
Removal |
1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal. |
2. |
Disconnect the manifold absolute pressure sensor connector (A). |
3. |
Remove the sensor (B) after loosening the mounting bolt from the intake manifold.
|
Installation |
|
1. |
Install in the reverse order of removal. |
Kia Niro 2017 (DE HEV) Service Manual: Hybrid Power Control Unit (HPCU) Schematic diagrams
Hybrid Power Control Unit
(HPCU) connector and high voltage cable
Hybrid Power Control Unit
(HPCU) terminal And Input/Output signal
ECM Terminal Function
Connector [C133-S]
(94Pin) : HPCU signal input and control
Terminal
...
Kia Niro 2017 (DE HEV) Service Manual: Rear Door Trim Components and components location
Component Location
1. Rear door trim
...