Kia Niro: Lane Keeping Assist System (LKAS) / Lane Keeping Assist System (LKAS) Unit Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / Lane Keeping Assist System (LKAS) / Lane Keeping Assist System (LKAS) Unit Repair procedures

Removal
  

When replacing the LKAS switch, check that the symbol mark in the cluster operates normally by pressing the ON/OFF switch.

1.

Disconnect the negative (-) battery terminal.

2.

Using a screwdriver or remover, remove the mirror wiring cover (A).

3.

Disconnect the LKAS unit connector (A).

4.

Remove the LKAS unit (B) by pulling out lock pins (A).

  

When pulling out the mounting bracket, be careful not to damage it.

Installation
1.

Install the LKAS unit.

2.

Connect the LKAS unit connector.

3.

Install the mirror wiring cover.

4.

Connect the negative (-) battery terminal.

Lane Keeping Assist System (LKAS) Unit Components and components location
Components ...

Lighting System
...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Component Location 1. Body Control Module (BCM) 2. Ultrasonic sensor    Front/rear parking assist control unit function is built into the Body Control Module (BCM). ...

Kia Niro 2017 (DE HEV) Service Manual: Fuel Pump Control Module (FPCM) Description and operation
Description Installed on the right hand side of the fuel tank, the Fuel Pump Control Module (FPCM) controls the DC motor mounted inside the low pressure fuel pump. The module compares instantaneous fuel pressure measured by the fuel pressure sensor (FPS) with target fuel pressure ...

© 2016-2023 www.kniro.net