Inspection |
1. |
Switch "OFF" the ignition. |
2. |
Disconnect the IATS connector. |
3. |
Measure resistance between the IATS terminals 3 and 4. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal. |
2. |
Disconnect the intake air temperature sensor connector (A). |
3. |
Remove the sensor (B) after loosening the mounting bolt from the intake manifold.
|
Installation |
|
1. |
Install in the reverse order of removal. |
Kia Niro (DE HEV) Owners Manual: Head lamp low beam (LHD)
1. Turn the low beam on without driver aboard.
2. The cut-off line should be projected in the cut-off line shown in the picture.
3. When aiming the low beam, vertical aiming should be adjusted after adjusting
the horizontal aiming.
4. If head lamp leveling device is equipped, adjust the head la ...
Kia Niro 2017 (DE HEV) Service Manual: Rear Door Module Repair procedures
Replacement
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pie ...