Kia Niro: Air Conditioning System / In-car Sensor Repair procedures
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Using a remover, remove the crash pad side cover [RH] (A).
|
| 3. |
Loosen the screw and remove the crash pad plate [RH] (A)
|
| 4. |
Remove the start stop button connector (A).
|
| 5. |
Lower and remove the center fascia panel (A).
|
| 6. |
Loosen the screw and remove the heater and air conditioner control unit (A).
|
| 7. |
Remove the heater and the air conditioning control unit connector (A).
|
| 8. |
Disconnect the room temperature sensor connector (A).
|
| 9. |
Press the fixing pin and remove the room temperature sensor (A).
|
| 10. |
Install in the reverse order of removal.
|
In-car Sensor Description and operation
Description
The in-car air temperature sensor is built into the heater & A/C control unit.
The sensor consists of a thermistor that measures the temperature inside the
vehicle. T ...
Photo Sensor Description and operation
Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar
radiation received by ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Specifications
Specification
Engine
Joint type
Max. permissible angle
Outer
Inner
Outer
Inner
1.6 GDI KAPPA
BJ#24
VTJ#24
46.5°
23°
...
Kia Niro 2017 (DE HEV) Service Manual: Mass Air Flow Sensor (MAFS) Description and operation
Description
MAFS uses a sensing element made of a hot-film to measure the mass of intake
air entering the engine and to send the signal to the ECM.
A large amount of intake air represents acceleration or high load conditions
while a small amount of intake air represents decelerati ...
