Kia Niro: Ignition System / Ignition Coil Repair procedures

Removal
1.

Turn ignition switch OFF and disconnect the battery negative (-) terminal.

2.

Remove the engine cover.

3.

Disconnect the ignition coil connector (A).

4.

Remove the ignition coil (A) after loosening the mounting bolt.

Ignition coil mounting bolt :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 Ib·ft)

  

When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

Installation
1.

Install in the reverse order of removal.

Ignition Coil Schematic diagrams
Circuit Diagram Ignition Coil Connector Terminal Function Connector View Ignition Coil Terminal Function Ignition Coil (Cylinder #1) ...

Spark Plug Specifications
Specification Item Specification Type ELR9ISP8+ Gap 0.7 - 0.8 mm (0.0276 - 0.0314 in.) ...

Other information:

Kia Niro (DE HEV) Owners Manual: Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when: 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. (It will operate normally when ...

Kia Niro (DE HEV) Owners Manual: Tailgate room lamp bulb replacement
1. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing. 2. Remove the bulb by pulling it straight out. 3. Install a new bulb in the socket. 4. Align the lens cover tabs with the lamp housing notches and snap the lens into place. CAUTION Be careful not to dirty or dam ...

© 2016-2023 www.kniro.net