Inspection |
1. |
Using mΩ tester, measure the line-to-line resistance.
|
2. |
Inspect the temperature sensor resistance.
|
3. |
Inspect the resolver sensor resistance.
|
4. |
Inspect the insulation resistance.
|
Removal |
1. |
Remove the hybrid drive motor & dual clutch transmission assembly from the vehicle. (Refer to DCT System - "DCT") |
2. |
Remove the engine clutch actuator (A).
|
3. |
Remove the concentric slave cylinder. (Refer to Clutch System - "Concentric Slave Cylinder Assembly") |
4. |
Remove the hybrid drive motor (A) by loosening the bolts.
|
Installation |
1. |
Install in the reverse order of removal.
|
2. |
Perform the procedure below after installing.
|
Kia Niro 2017 (DE HEV) Service Manual: BMS ECU Schematic diagrams
BMS ECU Terminal And Input/Output
Signal
Connector [B01-VC] (24pin) : High Voltage
Battery Cell Voltage Check Connector
Pin No.
Description
Connected to
1
-
-
2
...
Kia Niro 2017 (DE HEV) Service Manual: Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the KDS/GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS during idle at various engine speeds.
Pressure
Output Voltage (V) [Vref=5V]
...