High Voltage Shut-off Procedures |
|
High voltage components: High Voltage Battery Pack Assembly, Power Relay Assembly (PRA), BMS ECU, Hybrid Power Control Unit (HPCU), Hybrid Drive Motor, HSG, Electric A/C Compressor, Low DC/DC Converter (LDC), Power Cable, Electric Compressor etc. |
1. |
Switch "OFF" the ignition and disconnect the negative (-) terminal of the auxiliary 12V battery. |
2. |
Remove the safety plug cover (A) under the rear seat.
|
3. |
Unfasten the hook (A) in the direction of the arrow.
|
4. |
Unfasten the lever (A) in the direction of the arrow.
|
5. |
Remove the safety plug (A).
|
6. |
Wait at least 5 minutes or until the capacitor in the high voltage system is fully discharged. |
7. |
Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely.
|
Kia Niro (DE HEV) Owners Manual: Wireless smart phone charging system
A wireless smart phone charging system located in front of the center console.
Firmly close all doors, and turn the ignition to ACC or IGN ON. To start wireless
charging, place the smart phone equipped with wireless charging function on the
wireless charging pad.
For best wireless charging r ...
Kia Niro (DE HEV) Owners Manual: Windshield wipers
Operates as follows when the ignition switch is turned ON.
(1) MIST/ : For a single wiping cycle,
move the lever to this (MIST/ ) position
and release it. The wipers will operate continuously if the lever is held in this
position.
(2) OFF / O : Wiper is not in operation
(3) INT / --- : Wipe ...