Kia Niro: Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures
1. |
Switch "OFF" the ignition.
|
2. |
Disconnect the HO2S connector.
|
3. |
Measure resistance between the HO2S terminals 4 and 5 [B1/S1].
Specification: 2.5 - 4.0Ω [20°C(68°F)]
|
|
4. |
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
Specification: Approx. 9.0 Ω [21°C(69.8°F)]
|
|
5. |
Check that the resistance is within the specification.
|
Note that the SST (Part No.: 09392-1Y100 or 09392-2H100) can be used
for removing the heated oxygen sensor.
|
1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
|
2. |
Disconnect the connector (A), and then remove the sensor (B).
Heated oxygen sensor :
39.2 - 49.1 N·m (4.0 - 5.0 kgf·m, 28.9 - 36.2 lb·ft)
|


|
1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
|
2. |
Disconnect the connector (A), and then remove the sensor (B).
Heated oxygen sensor :
39.2 - 49.1 N·m (4.0 - 5.0 kgf·m, 28.9 - 36.2 lb·ft)
|


|
• |
Install the component to the specified torque.
|
• |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
• |
Keep the sensing element and connector free from cleaner, spray
or grease as oil substance may cause the sensor to malfunction.
|
• |
Sensor and its wiring may get damaged from contact with the exhaust
system (e.g. Exhaust Manifold, Catalytic Converter).
|
|
1. |
Install in the reverse order of removal.
|
Circuit Diagram
Harness Connector
[Bank 1 / Sensor 1]
[Bank 1 / Sensor 2]
...
Specification
Pressure
Output Voltage (V) [Vref=5V]
bar
[MPa (kgf/cm², psi)]
0
0 (0, 0)
0 ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Component Location
1 . Headlamp (Low/High Bi-function)
2. Position lamp
3. Turn signal lamp
4 . Fog lamp / Daytime Running Light (DRL)
5. Turn signal lamp (Door mirror / Side)
6. Vanity lamp
7. Map lamp
1 . T ...
Toyota Corolla 2019-2022 Owners Manual: Moon roof
Use the overhead switches to open and close the moon roof and tilt it up and
down.
Operating the moon roof
■ Opening and closing
1 Opens the moon roof*
The moon roof stops slightly before the fully open position to reduce wind noise.
Press the switch again to fully open the moon roof.
2 Closes ...