Peugeot 2008: Lighting and visibility / Headlamp beam height adjustment
Manually adjusting the halogen or LED technology headlamps
To avoid dazzling other road users, the height of these headlamp beams should be adjusted according to the load in the vehicle.
0 (Initial setting)
Driver only or driver + front passenger
1 5 people
2 5 people + load in the boot
3 Driver only + load in the boot
4 5 6 Not used
This information is provided as a guide only.
Depending on version, the unused positions may be required.
Automatic adjustment of the Full LED technology headlamps
This system automatically adjusts the height of the headlamp beams according to the load in the vehicle.
In the event of a malfunction,
this warning lamp comes on on the instrument panel, accompanied by the display
of a message and an audible signal.
The system then places the headlamp beams in the lowest position.
Have the system checked by a PEUGEOT dealer or a qualified workshop.
Do not touch the LED or
Full LED technology headlamps - risk of electrocution!
Direction indicators
Left or right: lower or raise the lighting control stalk, beyond the
point of resistance.
If you forget to cancel
the direction indicators for more than 20 seconds, the volume of the audible
...
Automatic illumination of headlamps
When the ring is at the "AUTO" position and a low level of ambient light is
detected by the rain/sunshine sensor, the number plate lamps, sidelamps and
dipped beam headlamps are switche ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: CVVT (Continuous Variable Valve Timing) System Repair procedures
Inspection
Variable Force Solenoind (VFS)
Refer to Engine Control / Fuel System - "Variable Force Solenoind (VFS)"
CVVT Oil Control Valve (OCV)
Refer to Engine Control / Fuel System - "CVVT Oil Control Valve (OCV)"
Removal
...
Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Safety Function of Power
Window
When driver door power window auto-up switch is operated, safety function is
activated.
1.
Safety function condition
When the force of 100N (using the 10N/mm spring) is detected while the
window is rising, the window is pull ...
