Kia Niro: Headlamp and front fog lamp aiming / Head lamp low beam (RHD)
1. Turn the low beam on without driver aboard.
2. The cut-off line should be projected in the cut-off line shown in the picture.
3. When aiming the low beam, vertical aiming should be adjusted after adjusting the horizontal aiming.
4. If head lamp leveling device is equipped, adjust the head lamp leveling device switch with 0 positions.
A : Vertical line of the left fog lamp bulb center
B : Vertical line of the right fog lamp bulb center
C : Horizontal line of fog lamp (low) bulb center
D : Cut – Off line
E : Car Axis
F : Upper limit
G : Ground
Head lamp low beam (LHD)
1. Turn the low beam on without driver aboard.
2. The cut-off line should be projected in the cut-off line shown in the picture.
3. When aiming the low beam, vertical aiming should be adjusted after ...
Front fog light
1. Turn the front fog lamp on without the driver aboard.
2. The cut-off line should be projected in the allowable range (shaded region). ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Rheostat Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the crash pad plate [LH] (A) after loosening the screws.
...
Kia Niro 2017 (DE HEV) Service Manual: Rear Bumper beam Assembly Repair procedures
Replacement
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pie ...
