Kia Niro: Lighting System / Hazard Lamp Switch Repair procedures

Inspection
1.

Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch.

[Audio Type]

Connector Pin Information

No.
Description
No.
Description
1
Battery (+)
21
IGN2
2
-
22
IGN1
3
Illumination (+)
23
Blower PWM
4
Sensor REF (5V)
24
Left Photo Sensor (-)
5
Driver side mode control actuator feedback
25
Right Photo Sensor (-)
6
Driver side temperature control actuator feedback
26
Blower relay
7
Intake actuator feedback
27
-
8
Evaporator temperature sensor
28
PTC relay 2
9
Ambient temperature
29
PTC relay 1
10
Driver side mode control actuator (Vent)
30
-
11
Driver side mode control actuator (Defogging)
31
Detent Out
12
Driver side temperature control actuator (Cool)
32
Hazard signal
13
Driver side temperature control actuator (Warmer)
33
P-CAN (High)
14
Intake actuator (FRE)
34
P-CAN (Low)
15
Intake actuator (REC)
35
Climate CAN (High)
16
HTD
36
Climate CAN (Low)
17
Rear defogging switch
37
Interlock (+)
18
Clean signal
38
Interlock (-)
19
Cluster Ionizer diagnosis
39
Sensor ground
20
Illumination (-)
40
Ground

[AVN Type]

No.
Description
No.
Description
1
Ground
7
-
2
-
8
Hazard switch_output
3
-
9
-
4
Hazard switch_input
10
-
5
-
11
-
6
Battery (+)
12
-

Removal

[Audio Type]

1.

Remove the heater & A/C control unit.

(Refer to Heating,Ventilation And Air Conditioning - "Heater & A/C Control Unit (DATC)")

[AVN Type]

1.

Remove the AVN head unit.

(Refer to Body Electrcal System - "AVN Head Unit")

Installation

[Audio Type]

1.

Install the heater & A/C control unit.

(Refer to Heating,Ventilation And Air Conditioning - "Heater & A/C Control Unit (DATC)")

[AVN Type]

1.

Install the AVN head unit.

(Refer to Body Electrcal System - "AVN Head Unit")

Overhead Console Lamp Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

Rheostat Components and components location
Components ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Height Adjuster Repair procedures
Replacement 1. Remove the front seat belt upper anchor. (Refer to Front Seat Belt - "Front Seat Belt Pretensioner") 2. After loosening the mounting bolts, remove the height adjuster (A). Tightening torque : ...

Toyota Corolla 2019-2022 Owners Manual: Turning the high beams on/off manually
■ Switching to the low beams Pull the lever to its original position. The Automatic High Beam indicator will turn off. Push the lever away from you to activate the Automatic High Beam system again. ■ Switching to the high beams Press the Automatic High Beam switch. The Automatic High Beam indic ...

© 2016-2022 www.kniro.net