Safety Precaution |
Precautions to take before servicing high voltage system |
|
||||||||||||||||||
|
||||||||||||||||||
|
||||||||||||||||||
|
Personal Protective Equipment |
Name |
Illustration |
Description |
Insulation gloves |
|
Used when inspecting or working on the high voltage components [Insulation performance : 1000V / 300A or above] |
Insulation shoes |
|
Used when inspecting or working on the high voltage components |
Insulation clothes |
|
|
Insulation helmet |
|
|
Safety glasses |
|
Used in the following cases : • During Removal & installation or inspection of the high voltage battery terminals or wiring, which spark might happen. • When working on the high voltage battery pack assembly. |
Face shield |
|
|
Insulation mat |
|
All removed high voltage components are placed on an insulation mat to prevent
safety accidents. |
Insulation sheet |
|
Insulation sheet is used to cover high voltage components to protect people
not wearing personal protective equipment from safety accidents. |
Warning tape |
|
Used for infomring that it is dangerous to come over this line. |
Personal Protective Equipment Inspection |
|
① Fold the insulation glove as above. ② Fold again 3~4 times to make it airtight. ② Squeeze the inflated glove to see if the glove is torn or damaged. |
Precautions to take when handling power cable |
|
Precautions to take when handling high voltage battery |
|
Precautions in case of fire on high voltage battery system |
|
Precautions in case of high voltage battery gas or electrolyte leakage |
|
Precautions when handling the vehicle after an accident |
|
Preparations when servicing the accident vehicle |
|
Precautions in case HEV is left unattended for a lengthy period |
|
Kia Niro 2017 (DE HEV) Service Manual: Temperature Control Actuator Repair procedures
Inspection
1.
Switch "OFF" the ignition.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the temperature control actuator operates to the cool position
when connecting 12V to termin ...
Kia Niro 2017 (DE HEV) Service Manual: License Lamps Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp assembly (A) after pressing the locking pin.
3.
Disconnect the license lamp connector (A).
4.
...