Kia Niro: Fuel Delivery System / Fuel Pressure Sensor (FPS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pressure Sensor (FPS) Repair procedures

Inspection

1.	Connect the KDS/GDS on the Data Link Connector (DLC).

Check that the output voltage is within the specification.

Pressure [kPa (kgf/cm², psi)]	Output Voltage (V) [Verf=5V]
50 (0.51, 7.3)	0.3
600 (6.12, 87.0)	2.5
1100 (11.2, 159.5)	4.5

Removal

1.	Release the residual pressure in fuel line. (Refer to Fuel Delivery system - "Release Residual Pressure in Fuel Line")

2.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

3.	Remove the rear seat cushion. ( Refer to Body - "Rear Seat Assembly" )

4.	Remove the fuel pump service cover (A).

5.	Disconnect the fuel pressure sensor connector (A).

6.	Remove the fuel pressure sensor fixing pin (A).

7.	Remove the fuel pressure sensor (B) from the fuel pump.

Installation

1.	Install in the reverse order of removal.

Fuel Pressure Sensor (FPS) Schematic diagrams

Circuit Diagram Fail-Safe Mode Item Fail-Safe Output Voltage (V) 12 ...

Delivery Pipe Repair procedures

Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, th ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Assist Handle Repair procedures
Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pie ...

Kia Niro (DE HEV) Owners Manual: Heated steering wheel
With the ignition switch in the ON position or engine start/stop button in the ON position, pressing the heated steering wheel button warms the steering wheel. The indicator on the button will illuminate. To turn the heated steering wheel off, press the button once again. The indicator on t ...