Kia Niro: ESP(Electronic Stability Program) System / Front Wheel Speed Sensor Repair procedures

Removal
1.

Remove the tire.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

  

Be careful not to damage the hub bolts when removing the wheel & tire.

2.

Remove the wheel speed sensor bolt (A).

Tightening torque:

7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

3.

Remove the wheel speed sensor bracket bolt (A).

Tightening torque :

8.8 - 13.7 N·m (0.9 - 1.4 kgf·m, 6.5 - 10.1 lb·ft)

4.

Remove the front wheel guard.

(Refer to body - "Front Wheel Guard")

5.

Disconnect the front wheel speed sensor.

6.

Installation is the reverse of removal.

Inspection
1.

Measure the output voltage between the terminal of the wheel speed sensor and the body ground.

  

In order to protect the wheel speed sensor, when measuring output voltage, a 100 ? resister must be used as shown.

2.

Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V - 0.84V

V_high : 1.18V - 1.68V

Frequency range : 1 - 2,500Hz

Front Wheel Speed Sensor Components and components location
Components 1. Front wheel speed sensor 2. Front wheel speed sensor cable ...

Rear Wheel Speed Sensor Components and components location
Components 1. Rear wheel speed sensor ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Specifications
Specification Air Conditioner Item Specification Compressor Type HES27 (Electric Scroll) Communication type CAN communication Oil type & Capacity POE Oil, ...

Kia Niro (DE HEV) Owners Manual: Vanity mirror lamp
Push the switch to turn the light on or off. : The lamp will turn on if this button is pressed. : The lamp will turn off if this button is pressed. CAUTION - Vanity mirror lamp Always have the switch in the off position when the vanity mirror lamp is not in use. If the sunvisor ...

© 2016-2024 www.kniro.net