Kia Niro: Front Seat Belt / Front Seat Belt Retractor Repair procedures

Replacement
1.

Remove the center pillar upper trim.

(Refer to Interior Trim - "Center Pillar Trim")

2.

Disconnect the connector (A).

3.

Remove the front seat belt upper anchor (A) after loosening the mounting bolt.

Tightening torque :

39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.8 - 39.8 lb·ft)

4.

Remove the front seat belt retractor (A) after loosening the bolts.

Tightening torque :

Lower : 39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.8 - 39.8 lb·ft)

Upper : 7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

5.

Install in the reverse order of removal.

  

Make sure that the connector is plugged in properly.

Replace any damaged clips.

Front Seat Belt Retractor Components and components location
Component Location 1. Front seat belt retractor ...

Height Adjuster Components and components location
Component Location 1. Height Adjuster ...

Other information:

Toyota Corolla 2019-2022 Owners Manual: Positioning a floor jack
When using a floor jack, follow the instructions in the manual provided with the jack and perform the operation safely. When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury. Location of the jack point ■ Front ■ R ...

Peugeot 2008 2019-2022 Owner's Manual: Bonnet
Stop & Start Before doing anything under the bonnet, you must switch off the ignition to avoid any risk of injury resulting from an automatic change to START mode. The location of the interior bonnet release lever prevents opening the bonnet when the left-hand front door is closed. When ...

© 2016-2022 www.kniro.net