Replacement |
Put on gloves to protect your hands. |
|
1. |
Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly") |
2. |
Remove the front seat outer shield cover. (Refer to Front Seat - "Front Seat Outer Shield Cover") |
3. |
Remove the front seat shield inner cover. (Refer to Front Seat - "Front Seat Shield Inner Cover") |
4. |
Push the lock pin (B), and remove the front seat headrest (A).
|
5. |
Remove the front seat lower protector (A).
|
6. |
Remove the front seat back board (A).
|
7. |
Remove the air ventilation duct (A). [UPPER]
[LOWER]
|
8. |
Disconnect the airbag connector (A), heater connector (B), and extension wiring connector (C).
|
9. |
Pull out the protector (A) from the front seat back frame.
|
10. |
Turn the front seat back cover inside out. Then pull out and remove the headrest guides (A) while pinching both sides of the lower part of the guides.
|
11. |
Remove the front seat back cover (A) from the front seat back frame.
|
12. |
After removing the velcro tape (A) and hog-ring clips (B) from the front of seat back, remove the front seat back cover (C).
|
13. |
Install in the reverse order of removal.
|
Kia Niro 2017 (DE HEV) Service Manual: Camshaft Position Sensor (CMPS) Troubleshooting
Signal Waveform
This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position
Sensor (CMPS) waveforms at idle. The PCM controls the injection and ignition timing
by using these signals.
Generally, the CKPS signal is used to detect the piston position whe ...
Kia Niro (DE HEV) Owners Manual: Battery capacity label
■ Example
❈ The actual battery label in the vehicle may differ from the illustration.
1. AGM90L-DIN : The Kia model name of battery
2. 90Ah(20HR) : The nominal capacity (in Ampere hours)
3. 170RC : The nominal reserve capacity (in min.)
4. 12V : The nominal voltage
5. 850CCA (SAE) : The ...