Kia Niro: SRSCM / Front Impact Sensor (FIS) Description and operation
| Description |
| • |
The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM. |
| • |
They are remote sensors that detect acceleration due to a collision at its mounting location. |
| • |
The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM. |
SRS Control Module (SRSCM) Repair procedures
Removal
1.
Remove the battery (-) cable.
Disconnect the battery negative ...
Front Impact Sensor (FIS) Components and components location
Components
...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Rear Door Latch Repair procedures
Replacement
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pie ...
Kia Niro 2017 (DE HEV) Service Manual: Injector Troubleshooting
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The top waveform
is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform
is from the low side (ground side) of the #1 injector and the bottom waveform is
from the low ...
