Kia Niro: Floor Console / Floor Console Assembly Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Floor Console / Floor Console Assembly Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Pull out and remove the gear knob and gear boots (A).

2.	Separate the floor console upper cover (A) by using a remover.

3.	Remove the floor console upper cover after disconnecting the connectors (A).

4.	Separate the floor console tray assembly (A).

5.	Remove the floor console tray after disconnecting the connectors (A).

6.	Remove the side console side covers (A) on both sides by pushing them rearward.

7.	Remove the console armrest mat (A).

8.	Loosen the console upper mounting bolts (A).

9.	Separate the console assembly after loosening the screws. [Front] [Rear]

10.	Disconnect the console wiring connector (A).

11.	Remove the console complete (A).

12.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Floor Console Assembly Components and components location

Component Location 1. Floor console assembly ...

Rear Console Cover Components and components location

Component Location 1. Rear console cover ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Virtual Engine Sound Speaker Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 3. Remove the high pitch horn and low pitch horn. (Refer to Body Electric ...

Kia Niro 2017 (DE HEV) Service Manual: BJ Boot Repair procedures
Replacement 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”) 3. Remove the Dynamic damper. ...