Kia Niro: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal
1.

Open the fuel filler door.

2.

Switch "OFF" the ignition and disconnect the negative (-) terminal of the auxiliary 12V battery.

3.

Remove the filler-neck assembly mounting bolt (A).

4.

Lift the vehicle.

5.

Remove the rear-LH wheel, tire, and the inner wheel house (A).

6.

Disconenct the fuel filler hose (A) and leveling hose (B).

7.

Disconnect the ventilation tube quick-connector (C).

8.

Remove the filler-neck assembly (B) after loosening the mounting bolt (A).

Installation
1.

Install in the reverse order of removal.

Fuel Line Repair procedures
Removal Low Pressure Fuel Line [High Pressure Fuel Pump ↔ Fuel Tank] 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Rele ...

Fuel Pump Control Module (FPCM) Description and operation
Description Installed on the right hand side of the fuel tank, the Fuel Pump Control Module (FPCM) controls the DC motor mounted inside the low pressure fuel pump. The module compares ...

Other information:

Toyota Corolla 2019-2022 Owners Manual: Approach warning (vehicle- to-vehicle distance control mode)
When your vehicle is too close to a vehicle ahead, and sufficient automatic deceleration via the cruise control is not possible, the display will flash and the buzzer will sound to alert the driver. An example of this would be if another driver cuts in front of you while you are following a vehic ...

Kia Niro 2017 (DE HEV) Service Manual: CVVT (Continuous Variable Valve Timing) System Schematic diagrams
Circuit Diagram Variable Force Solenoind (VFS) [Bank 1 / Intake] Harness Connector CVVT Oil Control Valve (OCV) [Bank 1 / Exhaust] Harness Connector ...

© 2016-2022 www.kniro.net