Kia Niro: AVN System / External AMP Repair procedures

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the crash pad center lower panel.

(Refer to Body - "Crash Pad Center Panel")

3.

Disconnect the external amplifier connectors (A).

4.

Remove the external amplifier (A) after loosening the mounting bolts and nuts.

Installation
1.

Install the external amplifier after connecting the connectors.

2.

Install the crash pad center lower panel.

3.

Connect the negative (-) battery terminal.

  

Make sure that the external amplifier connectors are plugged in properly.

Check the AVN system for normal operation.

External AMP Components and components location
Components Connector Pin Information No. Connector A No. Connector B 1 Battery (+) 1 ...

AVN Antenna Components and components location
Components [Roof Antenna (AM/FM + DAB + GNSS] ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the KDS/GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS during idle with IG ON. Pressure [kPa (kgf/cm², psi)] Output Voltage (V) [Vref = 5V] ...

Toyota Corolla 2019-2022 Owners Manual: Sensors
Two types of sensors, located behind the front grille and windshield, detect information necessary to operate the drive assist systems. A - Radar sensor B - Front camera WARNING ■To avoid malfunction of the radar sensor Observe the following precautions. Otherwise, the radar sensor may not opera ...

© 2016-2022 www.kniro.net