Kia Niro: Driveshaft Assembly / Dynamic Damper Components and components location

Kia Niro 2017 (DE HEV) Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Components and components location

Components

1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ housing
13. TJ circlip

TJ Joint Repair procedures
Replacement    • Special grease must be applied to the driveshaft joint. Do not substitut ...

Dynamic Damper Repair procedures
Replacement 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refe ...

Other information:

Kia Niro (DE HEV) Owners Manual: With the door lock button
To unlock a door, pull the door lock button (1) to the “Unlock” position. The red mark on the door lock button will be visible. To lock a door, push the door lock button (1) to the “Lock” position. If the door is locked properly, the red mark on the door lock button will not be ...

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of the PCV v ...

© 2016-2022 www.kniro.net