Kia Niro: Dual Clutch System / Dual Clutch Assembly Repair procedures

Removal
1.

Remove the hybrid drive motor & dual clutch transmission assembly from the vehicle.

(Refer to DCT System - "DCT")

2.

Remove the hybrid drive motor assembly from the DCT assembly.

(Refer to Hybrid Motor System - "Hybrid Drive Motor Assembly")

3.

Remove the spline hub (B) after removing a retaining ring (A).

4.

Remove the snap ring (A).

5.

Remove the dual clutch assembly (A) by using the special service tool (09430-C1180).

Installation
  

Check that the input shaft spline part (A) is sufficiently greased before installing the dual clutch assembly. If the input shaft spline part is not greased, apply the grease to 10 mm (0.3937 in.) on each spline end.

If an excessive amount of grease is applied, it may get scattered by centrifugal force, contaminating the clutch disc. This can lead to loss of friction force.

Specified grease : Extreme pressure grease for vehicle

Quantity : 0.15 - 0.25 g

1.

Install the double clutch assembly (A) by using double clutch installer (09430-2A240).

2.

Install the snap ring (A).

3.

Install the spline hub (B) and the retaining ring (A).

  

Check the installation condition of retaining ring after installing.

4.

Install the hybrid drive motor assembly to the DCT assembly.

(Refer to Hybrid Motor System - "Hybrid Drive Motor Assembly")

5.

Install the hybrid drive motor & dual clutch transmission assembly to the vehicle.

(Refer to DCT System - "DCT")

Dual Clutch Assembly Components and components location
Components 1. Retaining ring 2. Spline hub 3. Snap ring 4. Dual clutch assembly ...

Clutch Engagement Fork and Engagement Bearing Components and components location
Components 1. Engagement bearing 2 (Even) 2. Engagement bearing 1 (Odd) 3. Engagement bearing sleeve 4. Engagement fork 1 (Odd) 5. Engagement fork ...

Other information:

Peugeot 2008 2019-2023 Owner's Manual: Wiper control stalk
Before operating the wipers in wintry conditions, clear any snow, ice or frost from the windscreen, and from around the wiper arms and blades. Do not operate the wipers on a dry windscreen. In extremely hot or cold weather, check that the wiper blades are not stuck to the windscreen before ope ...

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Adjustment Inspect Glass Alignment 1. Inspect the step height between the roof panel (A) and the glass weatherstrip (B) and then adjust it if necessary. Alignment adjustment Standard value [mm(in.)] (1) Front edge : 0 mm (0 in.) ...

© 2016-2023 www.kniro.net