Kia Niro: Drive Belt System / Drive Belt Tensioner Repair procedures

Removal and Installation
1.

Remove the drive belt.

(Refer to Drive Belt System - "Drive Belt")

2.

Remove the mechanical tensioner (A).

Tightening torque :

18.6 - 23.5 N·m (1.9 - 2.4 kgf·m, 13.7 - 17.4 lb·ft)

3.

Remove the hydraulic tensioner.

(1)

Check that the hydraulic tensioner spring is compressed.

(2)

Unfasten the hydraulic tensioner mounting bolt (A).

(3)

Unfasten the hydraulic tensioner center bolt (B).

(4)

Remove the hydraulic tensioner mounting bolt (A).

(5)

Remove the hydraulic tensioner (C).

Tightening torque :

27.5 - 31.4 N·m (2.8 - 3.2 kgf·m, 20.3 - 23.1 lb·ft)

4.

Install in the reverse order of removal.

Inspection

Check the belt tensioner for excessive dust, crack, and damage. Replace if necessary.

Idler Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Drive Belt System - "Drive Belt") 2. Remove the idler (A). ...

Crankshaft Damper Pulley Repair procedures
Removal and Installation 1. Remove the RH front wheel. (Refer to Suspension System - "Wheel") 2. Remove the engine room under cover. ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Curtain Airbag (CAB) Module Description and operation
Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain airbag by using side impact sensor (SIS) signal.    ...

Kia Niro 2017 (DE HEV) Service Manual: Rear Door Window Glass Repair procedures
Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pie ...

© 2016-2024 www.kniro.net