Kia Niro: If you have a flat tire (with tire mobility kit) / Distributing the sealant
11. Immediately drive approximately 7~10km (4~6miles or, about 10min) to evenly distribute the sealant in the tire.
CAUTION
Do not exceed a speed of 60 km/h (35 mph). If possible, do not fall below a speed of 20 km/h (12 mph).
While driving, if you experience any unusual vibration, ride disturbance or noise, reduce your speed and drive with caution until you can safely pull off of the side of the road. Call for road side service or towing.
When you use the Tire Mobility Kit, the tire pressure sensors and wheel may be stained by sealant. Therefore, remove the tire pressure sensors and wheel stained by sealant and we recommend that inspect at an authorized Kia dealer.
Using the TMK
1. Detach the speed restriction label (1) from the sealant bottle (2), and place
it in a highly visible place inside the vehicle such as on the steering wheel to
remind the driver not to drive too ...
Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 minutes), stop
at a suitable location.
2. • Connect connection hose (10) of the compressor directly to the tire valve.
(18 inch tir ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Smart Cruise Control (SCC) ECU Schematic diagrams
Schematic Diagrams
Terminal Function
Pin No.
Terminal Function
1
B+
2
-
3
-
4
Ground
5
-
...
Kia Niro 2017 (DE HEV) Service Manual: Input Speed Sensor Description and operation
Description
•
The input shaft speed sensor is important in that it detects the input
shaft RPM and sends this information to the Transmission Control Module
(TCM).
•
This data is necessary for all operations including feedback control ...
