Kia Niro: Tire Pressure Monitoring System / Description and operation

Description

TREAD Lamp

Tire Under Inflation / Leak Warning.

1.

Turn on condition

When tire pressure is below allowed threshold

When rapid leak is detected by the sensor.

Indicates that tire needs to be re-inflated to placard pressure / repaired.

2.

Turn off condition

Under-inflation: When tire pressure is above warning threshold + hysteresis

Rapid Leak: When tire pressure is above leak warning threshold

DTC Warning

1.

Turn on condition

When the system detects a fault outside the receiver/ sensor

When the system detects a receiver fault

When the system detects a sensor fault

2.

Turn off condition

If the fault is considered 'critical', then the lamp stays on throughout the current ignition cycle (even if the DTC has been demoted). This is because it is important to bring the problem to the driver's attention. On the following ignition cycle, the demotion conditions will be re-checked. If the demotion conditions occur, the lamp will be turned off. It will stay on until DTC demotion checking is completed.

'Non-critical' faults are those that can occur temporarily e.g. vehicle battery under voltage. The lamp is therefore turned off when the DTC demotion condition occurs.

  

When driving in high altitude grades, it is natural for the atmospheric pressure to decrease. Therfore, please check the tire pressure and add more air as necessary.

Tire pressure can be decreased naturally due to decrease in ambient temperature (especially in winter). In this case, fill tires with air to the specification if warning lamp is illuminated as this is natural phenomenon.

System Fault

1.

General Function

The system monitors a number of inputs across time in order to determine that a fault exists.

Faults are prioritized according to the most likely cause.

Up to 15 faults can be saved.

Certain faults are not covered through DTC. These include:

a.

Sensor thermal shutdown (over 257°F/125°C).

b.

Stuck Ignition Line: requires observation of lamps at Ignition ON to diagnose.

Components and components location
Components Location 1. BCM (TPMS) 2. TPMS Sensor (FL) 3. TPMS Sensor (RL) 4. TPMS Sensor (RR) 5. TPMS Sensor (FR) ...

Troubleshooting
TPMS Inspection method Inspection    Find the inspection number by referring to the table above. Th ...

Other information:

Kia Niro (DE HEV) Owners Manual: Explanation of scheduled maintenance items
Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the vehicle is being driven in severe conditions, more frequent oil and filter changes are required. HSG (Hybrid starter & generator) belt The HSG belt should be ch ...

Kia Niro (DE HEV) Owners Manual: Check tire pressure
You can check the tire pressure in the information mode on the cluster. - Refer to “User settings mode” in chapter 4. Tire pressure is displayed 1~2 minutes later after driving. If tire pressure is not displayed when the vehicle is stopped, “Drive to display” message displays. ...

© 2016-2024 www.kniro.net