Kia Niro: Ignition System / Description and operation

Description

Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprogrammed in the memory of the ECM (Engine Control Module).

The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM. The ignition coil is activated, and timing is controlled.

Ignition System
...

Repair procedures
On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description The High Voltage Battery System provides the hybrid drive motor, HSG, and electric A/C compressor with electric energy and also reserves the electric energy generated during regeneration braking.It consists of the battery pack assembly, BMS ECU, power relay assembly, c ...

Kia Niro 2017 (DE HEV) Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with an L wrench (A). Tightening torque : 9.81 - 14.71 N·m (1.0 - 1.5 kgf·m, 7.2 - 10.8 lb·ft) ...

© 2016-2024 www.kniro.net