Removal |
1. |
Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work. |
2. |
Remove the roof trim. (Refer to Body (Interior and Exterior) - "Roof trim assembly") |
3. |
Disconnect the connector (A) from the curtain airbag module.
|
4. |
Loosen the curtain airbag bolts and nuts and then remove the curtain airbag. |
Installation |
1. |
Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work. |
2. |
Install the curtain airbag and then loosen the bolts and nuts.
|
3. |
Connect the curtain airbag connector. |
4. |
Install the loof trim. (Refer to Body (Interior and Exterior) - "Loof trim assembly") |
5. |
Reconnect the battery negative terminal. |
6. |
After installing the curtain airbag (CAB), confirm proper system operation: • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
|
Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Self Diagnosis
1.
Self-diagnosis process.
•
When operating the self-diagnostics, the below fault
(self-diagnostics cod ...
Kia Niro (DE HEV) Owners Manual: Immobilizer Indicator Light (With Smart Key)
This indicator light illuminates for up to 30 seconds:
• When the vehicle detects the smart key in the vehicle properly while the Engine
Start/Stop Button is ACC or ON.
- At this time, you can start the engine.
- The indicator light goes off after starting the engine.
This indicator light ...