Peugeot 2008: Driving / Cruise control - particular recommendations

Peugeot 2008 2019-2023 Owner's Manual / Driving / Cruise control - particular recommendations

Peugeot 2008. Cruise control - particular recommendations For the safety of everyone, only use the cruise control where the driving conditions allow running at a constant speed and keeping an adequate safety distance.

Remain vigilant when the cruise control is activated. If you hold one of the speed setting modification buttons down, a very rapid change in the speed of your vehicle may occur.

When descending a steep hill, the cruise control system cannot prevent the vehicle from exceeding the set speed. Brake if necessary to control the speed of your vehicle.

On steep climbs or when towing, the set speed may not be reached or maintained.

Peugeot 2008. Cruise control - particular recommendations Exceeding the programmed speed setting

The speed setting can be exceeded temporarily by pressing the accelerator pedal (the programmed speed flashes).

To return to the speed setting, release the accelerator pedal (when this speed is reached again, the display of the speed stops flashing).

Peugeot 2008. Cruise control - particular recommendations Operating limits

Never use the system in the following situations:

Speed limiter
Refer to the General recommendations on the use of driving and manoeuvring aids. This system prevents the vehicle from exceeding the speed programmed by the driver (speed setting). The speed limite ...

Cruise control
Refer to the General recommendations on the use of driving and manoeuvring aids and to Cruise control - particular recommendations. This system automatically keeps the vehicle’s speed at the crui ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: High voltage shut-off procedures
High Voltage Shut-off Procedures    • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure t ...

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Adjustment Inspect Glass Alignment 1. Inspect the step height between the roof panel (A) and the glass weatherstrip (B) and then adjust it if necessary. Alignment adjustment Standard value [mm(in.)] (1) Front edge : 0 mm (0 in.) ...

© 2016-2023 www.kniro.net