Kia Niro: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection

Check signal waveform of CKPS and CMPS using a KDS/GDS.

Specification: Refer to “Waveform”

Removal

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	Remove the air cleaner. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Disconnect the crankshaft position sensor connector (A).

4.	Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

Remove the crankshaft position sensor after loosening the mounting bolt (A).

Crankshaft position sensor mounting bolt :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

Installation

•	Install the component to the specified torque.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage it.

1.	Install in the reverse order of removal.

Crankshaft Position Sensor (CKPS) Schematic diagrams

Circuit Diagram Harness Connector ...

Crankshaft Position Sensor (CKPS) Troubleshooting

Signal Waveform This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveforms at idle. The PCM controls the injection and ignition tim ...

Other information:

Kia Niro (DE HEV) Owners Manual: ISOFIX anchorage and toptether anchorage (ISOFIX anchorage system) for children
The ISOFIX system holds a Child Restraint System during driving and in an accident. This system is designed to make installation of the Child Restraint System easier and reduce the possibility of improperly installing your Child Restraint System. The ISOFIX system uses anchors in the vehicle a ...

Peugeot 2008 2019-2023 Owner's Manual: Checking levels
Check all of the following levels regularly in accordance with the manufacturer's service schedule. Top them up if required, unless otherwise indicated. If a level drops significantly, have the corresponding system checked by a PEUGEOT dealer or a qualified workshop. The fluids must comply with ...