Kia Niro: Drive Belt System / Crankshaft Damper Pulley Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Mechanical System / Drive Belt System / Crankshaft Damper Pulley Repair procedures

Removal and Installation
1.

Remove the RH front wheel.

(Refer to Suspension System - "Wheel")

2.

Remove the engine room under cover.

(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")

3.

Remove the drive belt.

(Refer to Drive Belt System - "Drive Belt")

4.

Remove the crankshaft damper pulley (A).

Tightening torque :

[64.7 - 71.6 N·m (6.6 - 7.3 kgf·m, 47.7 - 52.8 Ib·ft)] + [39 - 41°]

  

Using the SST (09231-2M100, 09231-2J210) to hold the crankshaft damper pulley.

5.

Install in the reverse order of removal.

Drive Belt Tensioner Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Drive Belt System - "Drive Belt") 2. Remove the mechanical tensioner (A ...

Engine And Transaxle Assembly
...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Sunroof Switch Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console and remove the 2 screws holding the overhead console. Disconnect the switch connector and Map lamp connector, and then r ...

Kia Niro 2017 (DE HEV) Service Manual: Mass Air Flow Sensor (MAFS) Repair procedures
Inspection 1. Visually check the MAFS for the following: – Correct mounting direction – Any contamination, corrosion or damage on connector – Clogged or we ...

© 2016-2024 www.kniro.net