Troubleshooting |
Fault code |
Fail description |
Remedy |
60 |
Compressor CAN signal fault |
1. Check HV, LV connector connection. 2. Check LV connector pin condition. 3. Check vehicle inverter fuse condition. 4. A/C ON then check compressor operation. 5. If it does not operate, replace compressor. |
61 |
Compressor operation state error received |
|
62 |
Low voltage |
1. Check HV connector connection. 2. Check vehicle inverter fuse condition. 3. Check voltage level of high voltage battery. 4. A/C ON then check compressor operation. 5. If it does not operate, replace compressor. |
63 |
High voltage |
1. Identify vehicle model on compressor. 2. Check voltage level of high voltage battery. 3. A/C ON then check compressor operation. 4. If it does not operate, replace compressor. |
65 |
Overheat protection |
1. Check heating object in engine room. 2. Check A/C system for defects. 3. After 20 minutes, IG ON and A/C ON then check compressor operation. 4. If it does not operate, replace compressor. |
67 |
Over current protection |
1. Check cooling fan operation. 2. Check AAF(Active Air Flap) for short circuit. 3. After 20 minutes, IG ON and A/C ON then check compressor operation. 4. If it does not operate, replace compressor. |
69 |
Missed restart |
|
70 |
Over torque protection |
|
71 |
A/C
on Operating Permission Not Received |
1. Check the BMS. 2. Check the high voltage wiring shorted. |
72 |
A/C
Compressor Permission Power Not Received |
|
68 |
Current Measurement Error |
1. If it does not operate, replace compressor. 2. Check vehicle inverter fuse condition. |
78 |
Compressor Interlock Circuit OPEN |
Kia Niro (DE HEV) Owners Manual: Check tire pressure
You can check the tire pressure in the information mode on the cluster.
- Refer to “User settings mode” in chapter 4.
Tire pressure is displayed 1~2 minutes later after driving.
If tire pressure is not displayed when the vehicle is stopped, “Drive to
display” message displays. ...
Kia Niro 2017 (DE HEV) Service Manual: Virtual Engine Sound Speaker Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Remove the high pitch horn and low pitch horn.
(Refer to Body Electric ...