Component Location |
1. BMS ECU 2. Safety Plug 3. Main Relay (+) 4. Main Relay (-) 5. Pre Charge Relay 6. Pre-Charge Resistor |
7. Battery Current Sensor 8. Main Fuse [Safety Plug] 9. Battery Temperature Sensor 10. Battery Inlet Temperature Sensor |
Main Relays (Positive, Negative), Pre-Charge Relay, Pre-Charge Resistor, and Battery Current Sensor are integrated into the PRA. |
1. BMS ECU |
2. Safety Plug |
|
|
3. Main Relay (+) 4. Main Relay (-) 5. Pre-Charge Relay 6. Pre-Charge Resistor 7. Battery Current Sensor |
8. Main Fuse [Safety Plug] |
|
|
9. Battery Temperature Sensor 10. Battery Inlet Temperature Sensor |
|
|
Kia Niro 2017 (DE HEV) Service Manual: Fuel Pump Repair procedures
Inspection
[Fuel sender]
1.
Turn the ignition switch OFF, and then remove battery (-) terminal.
2.
Remove the fuel pump assembly.
3.
Using an ohmmeter, measure the resistance between terminals 1 and 6 of
sender c ...
Kia Niro (DE HEV) Owners Manual: Engine Oil Pressure Warning Light
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It remains on until the engine is started.
When the engine oil pressure is low.
If the engine oil pressure is low:
1.Drive carefully to the nearest safe location and stop ...