1. After driving approximately 7~10 km (4~6 miles or about 10 minutes), stop at a suitable location.
2. • Connect connection hose (10) of the compressor directly to the tire valve.
(18 inch tire only)
• Connect the filling hose (3) of the compressor (clip mounted side) directly and
then connect the filling hose (3) (opposite side) to the tire valve. (16 inch tire
only)
3. Connect between compressor and the vehicle power outlet using the cable and connectors.
4. Adjust the tire inflation pressure to 250 kPa (36 psi/2.5 bar). With the ignition switched on, proceed as follows.
- To increase the inflation pressure: Switch on the compressor, position I. To check the current inflation pressure setting, briefly switch off the compressor.
WARNING
Do not let the compressor run for more than 10 minutes, otherwise the device will overheat and may be damaged.
- To reduce the inflation pressure: Press the button (9) on the compressor.
CAUTION
If the inflation pressure is not maintained, drive the vehicle a second time, refer to Distributing the sealant. Then repeat steps 1 to 4.
Use of the TMK may be ineffectual for tire damage larger than approximately 4 mm (0.16 in).
We recommend that you contact an authorized Kia dealer if the tire cannot be made roadworthy with the Tire Mobility Kit.
WARNING
The tire inflation pressure must be at least 250 kPa (36 psi/2.5 bar). If it is not, do not continue driving. Call for road side service or towing.
Kia Niro 2017 (DE HEV) Service Manual: Input Speed Sensor Repair procedures
Removal
1.
Remove the clutch actuator.
(Refer to Dual Clutch Transmission Control System - "Clutch Actuator
Assembly")
2.
Remove the connector from the bracket after disconnecting the connector
and then remove the input spee ...
Kia Niro 2017 (DE HEV) Service Manual: Injector Description and operation
Description
The GDI injector is similar to a standard injector, but sprays fuel at a much
higher pressure directly into the combustion chamber and has a swirl disc to get
the fuel swirling as it exits the nozzle. This aids in atomization of the fuel.
The ECM controls both the fee ...