Peugeot 2008: Practical information / Checking levels

Check all of the following levels regularly in accordance with the manufacturer's service schedule. Top them up if required, unless otherwise indicated.

If a level drops significantly, have the corresponding system checked by a PEUGEOT dealer or a qualified workshop.

Peugeot 2008. Checking levels The fluids must comply with the manufacturer's requirements and with the vehicle's engine.

Peugeot 2008. Checking levels Take care when working under the bonnet, as certain areas of the engine may be extremely hot (risk of burns) and the cooling fan could start at any time (even with the ignition off).

Used products

Peugeot 2008. Checking levels Avoid prolonged contact of used oil or fluids with the skin.

Most of these fluids are harmful to health and very corrosive.

Peugeot 2008. Checking levels Do not discard used oil or fluids into sewers or onto the ground.

Empty used oil into the containers reserved for this purpose at a PEUGEOT dealer or a qualified workshop.

Engine oil

Peugeot 2008. Checking levels The level is checked, with the engine having been switched off for at least 30 minutes and on level ground, either using the oil level indicator in the instrument panel when the ignition is switched on (for vehicles equipped with an electric gauge), or using the dipstick.

It is normal to top up the oil level between two services (or oil changes). It is recommended that you check the level, and top up if necessary, every 3,000 miles (5,000 km).

Peugeot 2008. Checking levels In order to maintain the reliability of the engine and emissions control system, never use additives in the engine oil.

Checking using the dipstick

For the location of the dipstick, please refer to the illustration of the corresponding engine compartment.

Peugeot 2008. Checking levels

Do not start the engine if the level is:

Peugeot 2008. Checking levels Oil grade

Before topping up or changing the engine oil, check that the oil is suitable for the engine and complies with the recommendations in the service schedule supplied with the vehicle (or available from your PEUGEOT dealer and qualified workshops).

Use of non-recommended oil may invalidate the contractual warranty in the event of engine failure.

Topping up the engine oil level

For the location of the engine oil filler cap, please refer to the corresponding under-bonnet engine compartment illustration.

Peugeot 2008. Checking levels Within 30 minutes of adding oil, the oil level indication in the instrument panel when the ignition is switched on is not valid.

Brake fluid

Peugeot 2008. Checking levels The level of this fluid should be close to the "MAX" mark. If not, check the brake pad wear.

To know how often the brake fluid should be replaced, refer to the manufacturer's servicing schedule.

Peugeot 2008. Checking levels Clean the cap before removing it to refill. Use only DOT4 brake fluid from a sealed container.

Engine coolant

Peugeot 2008. Checking levels It is normal to top up this fluid between two services.

The check and top-up must only be done with the engine cold.

A low level presents a risk of serious damage to the engine.

The level of this fluid should be close to the "MAX" mark but should never exceed it.

If the level is close to or below the "MIN” mark, it is essential to top up.

When the engine is hot, the temperature of this fluid is regulated by the fan.

As the cooling system is pressurised, wait at least one hour after switching off the engine before carrying out any work.

In order to avoid the risk of scalding if you need to top up in an emergency, wrap a cloth around the cap and unscrew the cap by two turns to allow the pressure to drop.

Once the pressure has dropped, remove the cap and top up to the required level.

Screenwash fluid

Peugeot 2008. Checking levels Top up to the required level when necessary.

Fluid specification

The fluid must be topped up with a ready-to-use mixture.

In winter (temperatures below zero), a liquid containing an agent to prevent freezing must be used which is appropriate for the prevailing conditions, in order to protect the elements of the system (pump, tank, ducts, jets, etc.).

Peugeot 2008. Checking levels Filling with pure water is prohibited under all circumstances (risk of freezing, limestone deposits, etc.).

AdBlue (BlueHDi)

An alert is triggered when the reserve level is reached.

For more information on Indicators and in particular the AdBlue range indicators, refer to the corresponding section.

To avoid the vehicle being immobilised in accordance with regulations, you must top up the AdBlue tank.

For more information on AdBlue® (BlueHDi), and in particular on the supply of AdBlue, refer to the corresponding section.

Engine compartment
The engine shown here is an example for illustrative purposes only. The locations of the following elements may vary: Air filter. Engine oil dipstick. Engine oil filler cap. Petrol engine Diesel ...

Checks
Unless otherwise indicated, check these components in accordance with the manufacturer's service schedule and according to your engine. Otherwise, have them checked by a PEUGEOT dealer or a qualified ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description AVN system The AVN system simplifies system manipulation and by unifying the vehicle information and user information displays, improves information search and operation experience. The system is basically composed of a keyboard for the operation of combined function ...

Kia Niro (DE HEV) Owners Manual: Securing a Child Restraint System with a lap/shoulder belt
When not using the ISOFIX system, all Child Restraint Systems must be secured to a rear seat with the lap part of a lap/shoulder belt. Installing a Child Restraint System with a lap/shoulder belt To install a Child Restraint System on the rear seats, do the following: 1. Place the Child Restr ...

© 2016-2023 www.kniro.net