Kia Niro: Interior Trim / Center Pillar Trim Repair procedures
[Center pillar lower
trim]
|
Put on gloves to protect your hands.
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
| • |
Be careful not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
| 2. |
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
| 3. |
Carefully remove the front door body side weatherstrip.
|
| 4. |
Carefully remove the rear door body side weatherstrip.
|
| 5. |
Using a remover, remove the center pillar lower trim (A).
|
| 6. |
Install in the reverse order of removal.
| •
|
Make sure that the connector is plugged in properly.
|
| •
|
Replace any damaged clips.
|
|
|
[Center pillar upper
trim]
|
Put on gloves to protect your hands.
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
| • |
Be careful not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the center pillar lower trim.
|
| 2. |
Disconnect the seat belt (B) from the EFD system (A).
|
| 3. |
Remove the center pillar lower trim (A) after loosening the bolt.
|
| 4. |
Install in the reverse order of removal.
|
Make sure that the connector is plugged in properly.
|
|
Component Location
1. Center pillar lower trim
2. Center pillar upper trim
...
Component Location
1. Rear transverse trim
...
Other information:
Kia Niro (DE HEV) Owners Manual: To resume cruise control set speed
If any method other than the CRUISE button was used to cancel cruising speed
and the system is still activated, the cruising speed will automatically resume
when you move the lever up (to RES+).
If you move the lever up (to RES+), the speed will resume to the recently set
speed. When the sp ...
Kia Niro 2017 (DE HEV) Service Manual: Fuel Pump Repair procedures
Inspection
[Fuel sender]
1.
Turn the ignition switch OFF, and then remove battery (-) terminal.
2.
Remove the fuel pump assembly.
3.
Using an ohmmeter, measure the resistance between terminals 1 and 6 of
sender c ...
Center Pillar Trim Components and components location
Rear Transverse Trim Components and components location