Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel. (Refer to Body - "Crash Pad") |
3. |
Remove the knee air bag. (Refer to Restraint - "Knee Airbag(KAB) Module") |
4. |
Remove the Steering column and shaft. (Refer to the Steering System - "Steering Columm and Shaft") |
5. |
Disconnect the stop lamp switch (A) and brake pedal stroke sensor connector (B).
|
6. |
Loosen the nut (A) and then remove the bracket.
|
7. |
Remove the snap pin (A) and clebis pin (B).
|
8. |
Loosen the brake pedal nuts and then remove the brake pedal.
|
Installation |
1. |
Installation is the reverse of removal. |
2. |
Check the brake pedal operation. |
3. |
Conduct the pedal traval sensor (PTS) calibration. |
Diagnostic Procedure Using a Diagnostic Instrument |
The following section describes how to diagnose faults using a diagnostic instrument.
1. |
Connect the diagnostic instrument to the self-diagnostic connector (16-pin) beneath the crash pad on the side of driver's seat, and then turn on the ignition to activate the diagnostic instrument. |
2. |
In the GDS Vehicle Type Selection menu, select "Vehicle Type" and "Brake/VDC/AHB" System, and then opt for "OK." Pedal Travel Sensor (PTS) Calibration
|
3. |
Turn ignition switch off after calibration procedure. |
4. |
Confirm success or failure of calibration. |
Kia Niro (DE HEV) Owners Manual: To set cruise control speed
1. Press the CRUISE / button on the
steering wheel, to turn the system on. The cruise indicator light will illuminate.
2. Accelerate to the desired speed, which must be more than approximately 30
km/h (20 mph).
3. Move the lever down (to SET-), and release it at the desired speed. The cru ...
Kia Niro 2017 (DE HEV) Service Manual: Multimedia Jack Repair procedures
Removal
Multimedia Jack
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver or use ...