Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the crash pad plate [LH] (A) after loosening the screws.
|
4. |
Disconnect the crash pad side switch connector (A).
|
5. |
Remove the crash pad side switch (A) after loosening the screws.
|
Installation |
1. |
Install the crash pad side switch. |
2. |
Connect the crash pad side switch connector. |
3. |
Install the crash pad plate [LH]. |
4. |
Install the crash pad lower panel. |
5. |
Connect the negative (-) battery terminal. |
Inspection |
1. |
Disconnect the BSD switch connector from the crash pad side switch.
|
2. |
Operate the BSD switch, then check for continuity between terminals and BSD switch connector.
|
Kia Niro 2017 (DE HEV) Service Manual: Variable Force Solenoid (VFS) Description and operation
Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve
timing of the intake and exhaust valve in accordance with the ECM control signal
which is calculated by the engine speed and load. By controlling CVVT, the valve
overlap or underlap occurs, wh ...
Kia Niro 2017 (DE HEV) Service Manual: Power Relay Assembly (PRA) Description and operation
Description
The Power Relay Assembly (PRA) consists of the positive and negative main relays,
pre-charge relay, pre-charge resistor and battery current sensor. It is located
inside the battery pack assembly and controls the high voltage power circuit between
the high voltage batte ...