Kia Niro: Blind Spot Detection system (BSD) / Blind Spot Detection Radar Calibration Description and operation
| Description |
To correctly sense vehicles on the neighboring lanes using the radar, the direction of the sensor and the direction of the vehicle must be aligned.
This is the BSD unit alignment. If this alignment is not performed as in illustration below, it may cause degradation of detection performance and false alarms.
In particular, vehicles with damaged rear bumper from accident and vehicles that replaced BSD unit must carry out this alignment procedure.
| 1. |
The vehicles with damaged rear bumper from accident and vehicles that replaced BSD unit must perform BSD alignment using KDS/GDS. |
| 2. |
Select "BSD Radar Calibration" procedure in BSD system.
|
| 3. |
Perform the "BSD Radar Calibration" procedure as indicated on KDS/GDS screen.
|
Blind Spot Detection Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
...
Blind Spot Detection Switch Schematic diagrams
Circuit Diagram
...
Other information:
Kia Niro (DE HEV) Owners Manual: Tires and wheels (Except europe)
✽ NOTICE
We recommend that when replacing tires, use the same originally supplied
with the vehicles. If not, that affects driving performance.
When driving in high altitude grades, it is natural for the atmospheric
pressure to decrease. Therefore, please check the tire pressure and a ...
Kia Niro 2017 (DE HEV) Service Manual: Transmission Gear Oil Repair procedures
Inspection
Oil Level Check
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the oil filler plug (A or B).
3.
Check the condition of the oil and m ...
