Kia Niro: Driveshaft Assembly / BJ Boot Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures

Replacement

1.	Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”)

2.	Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”)

3.	Remove the Dynamic damper. (Refer to Driveshaft Assembly - “Dynamic Damper”)

4.	Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.	Remove the BJ boot.

Install in the reverse order of removal.

•	Do not disassemble the BJ assembly.

•	Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.

•	The boot band should be replaced with a new one.

7.	Check the front alignment. (Refer to Suspension System - "Front Alignment")

BJ Boot Components and components location

Components 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band ...

Front Axle Assembly / Front Hub / Knuckle

...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Auxiliary 12V Battery Repair procedures
Removal Auxiliary 12V Battery 1. Open the trunk. 2. Remove the luggage side trim [RH] side cover (A). 3. Turn the ignition switch OFF and disconnect the battery negative (-) terminal (A). ...

Kia Niro (DE HEV) Owners Manual: FM reception
AM and FM radio signals are broadcast from transmitter towers located around your city. They are intercepted by the radio antenna on your vehicle. This signal is then received by the radio and sent to your vehicle speakers. When a strong radio signal has reached your vehicle, the precise engi ...