Kia Niro: Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Inspection
1.

Connect the KDS/GDS on the Data Link Connector (DLC).

2.

Switch "ON" the ignition.

3.

Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Accelerator
Position
Output Voltage (V) [Vref = 5V]
APS1
APS2
C.T
0.7 - 0.8
0.33 - 0.43
W.O.T
3.98 - 4.22
1.98 - 2.13

Removal
1.

Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.

Disconnect the accelerator position sensor connector (A).

3.

Remove the accelerator position sensor after loosening the mounting nuts (A).

Accelerator pedal sensor mounting bolt :

12.7 - 15.7 N·m (1.3 - 1.6 kgf·m, 9.4 - 10.6 lb·ft)

Installation
1.

Install in the reverse order of removal.

Accelerator Position Sensor (APS) Schematic diagrams
Circuit Diagram Harness Connector ...

Injector Specifications
Specification Item Specification Coil Resistance (Ω) 1.425 - 1.575 [20°C(68°F)] ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: High voltage shut-off procedures
High Voltage Shut-off Procedures    • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure t ...

Kia Niro (DE HEV) Owners Manual: Radar check message
If the radar or cover is dirty or obscured with foreign matter such as snow, this message (“Smart Cruise Control disabled temporarily”) will appear and it will disappear after for a while. In this case, the system may not function temporarily, but it does not indicate a malfunction of the ...

© 2016-2023 www.kniro.net