Kia Niro: Tires/Wheels / Wheel Repair procedures
| Hub nut tightening sequence |
Tighten the hub nuts in the following sequence.
|
Tightening torque: 88.3 - 107.9 N·m (9.0 - 11.0 kgf·m, 65.1 - 79.6 lb·ft) |
When using an impact gun, final tightening torque should be checked using a torque wrench. |
Run out inspection
| 1. |
Jack up the vehicle. |
| 2. |
Measure the wheel run-out by using a dial indicator as shown below.
|
| 3. |
If measured value exceeds the standard value, replace the wheel.
|
Tire Repair procedures
Tire Wear
•
Using tires and wheel other than the recommended sizes could
cause unusual ...
Alignment Repair procedures
Front wheel alignment
When using a commercially available computerized wheel alignment equipment
to inspect the f ...
Other information:
Kia Niro (DE HEV) Owners Manual: Emission control system
The emission control system of your vehicle is covered by a written limited warranty.
Please see the warranty information contained in the Warranty & Maintenance book
in your vehicle.
Your vehicle is equipped with an emission control system to meet all applicable
emission regulations.
Th ...
Kia Niro 2017 (DE HEV) Service Manual: Front Seat Belt Retractor Repair procedures
Replacement
1.
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
2.
Disconnect the connector (A).
3.
Remove the front seat belt upper anchor (A) after loosening th ...
