| Failure Diagnosis |
| 1. |
In principle, ESP and TCS controls are prohibited in case of ABS failure. |
| 2. |
When ESP or TCS fails, only the failed system control is prohibited. |
| 3. |
However, when the solenoid valve relay should be turned off in case of ESP failure, refer to the ABS fail-safe. |
| 4. |
Information on ABS fail-safe is identical to the fail-safe in systems where ESP is not installed. |
Memory of Fail Code
| 1. |
It keeps the code as far as the backup lamp power is connected. (O) |
| 2. |
It keeps the code as far as the HCU power is on. (X) |
Failure Checkup
| 1. |
Initial checkup is performed immediately after the HECU power on. |
| 2. |
Valve relay checkup is performed immediately after the IG2 ON. |
| 3. |
It executes the checkup all the time while the IG2 power is on. |
Countermeasures in Fail
| 1. |
Turn the system down and perform the following actions and wait for HECU power OFF. |
| 2. |
Turn the valve relay off. |
| 3. |
Stop the control during the operation and do not execute any until the normal condition recovers. |
Warning Lamp ON
| 1. |
ESP warning lamp turn on for 3sec after IGN ON. |
| 2. |
ESP function lamp blinks when ESP Act. |
| 3. |
If ESP fail occured, ESP warning turns ON. |
| 4. |
ESP OFF lamp turn on in case of
|
Description and operation
Front Wheel Speed Sensor Components and components locationKia Niro 2017 (DE HEV) Service Manual: Immobilizer Control Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the main crash pad assembly.
(Refer to Body - "Main Crash Pad Assembly")
3.
Disconnect the connector of the immobilizer unit and then remov ...
Kia Niro 2017 (DE HEV) Service Manual: Fuel Pump Control Module (FPCM) Schematic diagrams
Circuit Diagram
Terminal Information
Terminal Illustration
Terminal Function
Pin No.
Description
1
Fuel Sender (-)
2
Fuel pressure sensor (FPS) signal inpu ...