Kia Niro: Tire Pressure Monitoring System / TPMS Receiver Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable. |
| 2. |
Remove the glove box. (Refer to Body - "Glove Box Housing") |
| 3. |
Disconnect the blower motor connector (A).
|
| 4. |
Disconnect the body control module (BCM) connector (A).
|
| 5. |
Loosen the body control module bolt and nut.
|
| 6. |
Disconnect the connector and then remove the body control module.
|
| 7. |
Install in the reverse order of removal.
|
| Diagnosis procedure by using diagnostic device |
The main contents of diagnostic method using diagnostic device are as follows:
| 1. |
Connect self-diagnosis connector (16 pins) located in the lower driver side crash pad to self-diagnostic device, and then turn on the self-diagnostic device after key is ON. |
| 2. |
Select the "vehicle model" and "TPMS" on KDS/GDS vehicle selection screen, then select OK. [Vehicle Name Writing Method 1]
[Vehicle Name Writing Method 2]
[Vehicle Name Writing Method 3]
[Wheel Sensor ID Writing Method 1]
[Wheel Sensor ID Writing Method 2]
[Wheel Sensor ID Writing Method 3]
[Wheel Sensor ID Writing Method 4]
|
TPMS Receiver Description and operation
Operation
1.
General Function
•
Auto-learn takes place only once per Ignition cycle.
•
On successfu ...
Steering System
...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Front Strut Assembly Components and components location
Components
1. Strut assembly
2. Insulator
3. Bearing
4. Spring upper pad
5. Spring
6. Dust cover
7. Spring lower pad
...
Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Troubleshooting
Symptom
Suspected Area
Remedy
Water leaks from panorama sunroof
Deteriorated roof lid weatherstrip
Replace
Excessive roof lid-to-body clearance and improperly fitted weathers ...
