Kia Niro: Driveshaft Assembly / TJ Joint Components and components location
| Components |
| [LH] |
|
1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot 10. Spider assembly 11. Retainer ring 12. TJ housing |
13. Housing circlip |
| [RH] |
|
1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot 10. Spider assembly 11. Retainer ring 12. TJ housing |
13.Housing circlip |
Front Driveshaft Repair procedures
Removal
1.
Remove the wheel and tire.
Tightening torque:
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)
...
TJ Joint Repair procedures
Replacement
•
Special grease must be applied to the driveshaft joint. Do not
substitut ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: DCT Control Module (TCM) Repair procedures
Inspection
1.
TCM ground circuit test : Measure the resistance between TCM and chassis
ground. (Inspect the terminal connected to the chassis ground with the back
of harness connector as the inspection point of TCM side.)
Specification : Below ...
Kia Niro (DE HEV) Owners Manual: Scheduled maintenance service precaution
Follow the Normal Maintenance Schedule if the vehicle is usually operated where
none of the following conditions apply. If any of the following conditions apply,
follow the Maintenance Under Severe Usage Conditions.
Repeated driving short distance of less than 8 km (5 miles) in normal temper ...
