Kia Niro: Light bulbs / Tail lamp (inside) bulb replacement
1. Open the tailgate.
2. Remove the service cover.
3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
4. Remove the bulb from the socket by pressing it in and rotating it counter-clockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket.
5. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.
6. Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly. Push the socket into the assembly and turn the socket clockwise.
7. Install the service cover by putting it into the service hole.
Stop and tail lamp bulb replacement
1. Open the tailgate.
2. Open the service cover.
3. Loosen the light assembly retaining screws with a cross-tip screwdriver.
4. Remove the rear combination lamp assembly from the body of the ve ...
Stop and tail lamp (LED type) bulb replacement
If the stop and tail lamp (LED) does not operate, we recommend that you checked
an authorized Kia dealer. ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Virtual Engine Sound System Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Disconnect the VESS unit connector (A).
4.
...
Kia Niro 2017 (DE HEV) Service Manual: Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Switch "OFF" the ignition.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the specific ...
