Kia Niro: SRSCM / Seat Belt Buckle Switch (BS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Repair procedures

Removal
1.

Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.

2.

Remove the front seat assembly.

(Refer to the Body - "Front seat")

3.

Loosen the mouting bolt and then remove the seat belt buckle switch.

Installation
1.

Install in the reverse order of removal.

  

If the seat belt is not attached, and the ignition switch to the ON position the seat belt warning lamp lights should be lit continuously, it was 6 seconds.

However, the check ride after Passenger seats.

Seat Belt Buckle Switch (BS) Components and components location
Components ...

Brake System
...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Rain Sensor Description and operation
Description Integrated Rain Sensor Integrated rain sensor (A) controls three systems: front wiper, auto-light, and central air conditioner. 1. Wiper Control System When the multifunction switch on the right receives "AUTO" switch signal, ...

Kia Niro (DE HEV) Owners Manual: Battery replacement
■ Folding key ■ Smart Key A transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure. 1. Insert a slim tool into the slot and gently pry open the folding key center cover or Pry open the rear cover ...

© 2016-2025 www.kniro.net