Adjustment |
Glass Adjustment
Check the glass run channel for damage or deterioration, and replace it if necessary. |
1. |
Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") |
2. |
Remove the rear door window glass mounting hole plug (A). |
3. |
Carefully move the rear door window glass (A) until the glass mounting bolts are visible, then loosen them.
|
4. |
Check that the glass moves smoothly. |
Door Striker Adjustment
Make sure the door latches securely without slamming it. If necessary adjust the striker (A): The striker nuts are fixed. The striker can be fine adjusted up or down, and in or out. |
1. |
Loosen the screws (B) just enough for the striker to move.
|
2. |
Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment. |
3. |
Hold the outer handle out, and push the door against the body to be sure the striker allows a flush fit. If the door latches properly, tighten the screws and recheck. |
Door Position Adjustment
After installing the door, check for a flush fit with the adjacent body panels, then check for equal gaps between the front, rear, and bottom, door edges and the body. Check that the door and body edges are parallel. Before adjusting, replace the mounting bolts. |
1. |
Check that the door and body edges are parallel.
|
2. |
Place the vehicle on a firm, level surface when adjusting the doors. |
3. |
Adjust at the hinges (A) :
|
4. |
Grease the pivot portions of the hinges indicated by the arrows. |
5. |
Check for water leaks. |
Kia Niro (DE HEV) Owners Manual: Changing the coolant
We recommend that the coolant be replaced by an authorized Kia dealer.
CAUTION
Put a thick cloth around the radiator cap before refilling the coolant in
order to prevent the coolant from overflowing into engine parts such as the alternator.
WARNING - Coolant
Do not use radiator coolant or a ...
Kia Niro 2017 (DE HEV) Service Manual: Cylinder Block Repair procedures
Disassembly
•
Be sure to read and follow the “General Safety Information and
Caution” before doing any work related with the high voltage system.
Failure to follow the safety i ...