Kia Niro: Ignition System / Repair procedures

On-vehicle Inspection
Inspect ignition coil assembly and Perform spark test
1.

Check for DTCs.

  

If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide)

2.

Check if sparks occur.

(1)

Remove the engine cover.

(2)

Remove the ignition coils.

(Refer to Ignition System - "Ignition Coil")

(3)

Using a spark plug wrench, remove the spark plugs.

(4)

Disconnect the injector extension connectors.

(5)

Ground the spark plug to the engine.

(6)

Check if sparks occur at each spark plug while engine is being cranked.

  

Do not crank the engine for more then 5 seonds.

3.

If sparks do not occur, perform the following test.

4.

Using a spark plug wrench, install spark plugs.

5.

Install the ignition coils.

6.

Install the engine cover.

Description and operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprog ...

Ignition Coil Electrical and electronic specifications
Specification Item Specification Engine Time (RPM) 1000 2000 3000 4000 5000 ...

Other information:

Kia Niro (DE HEV) Owners Manual: Head lamp low beam (LHD)
1. Turn the low beam on without driver aboard. 2. The cut-off line should be projected in the cut-off line shown in the picture. 3. When aiming the low beam, vertical aiming should be adjusted after adjusting the horizontal aiming. 4. If head lamp leveling device is equipped, adjust the head la ...

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Components Location 1. High Voltage Battery System Assembly 2. High Voltage Battery Pack Assembly 3. Power Relay Assembly (PRA) 4. High Voltage Front Cover 5. High Voltage Rear Cover 1. High Voltage Battery System Assemb ...

© 2016-2026 www.kniro.net