Kia Niro: Rear Wiper/Washer / Rear Washer Switch Repair procedures

Inspection

Multifunction Switch Inspection

1.

Check for continuity between the terminals in each switch position as shown below.

[Left Handle Drive]

Switch
Switch position
Switch terminal
Resistance (?, ±3.5%)
Front wiper switch
MIST
1-9
330
OFF
?
Intermittent (AUTO)
800
LOW
1,800
HIGH
5,700
Rear wiper switch
OFF
9-16
?
LOW
910
HIGH
2,910

[Right Handle Drive]

Switch
Switch position
Switch terminal
Resistance (?, ±3.5%)
Front Wiper switch
MIST
3-16
330
OFF
?
Intermittent (AUTO)
800
LOW
1,800
HIGH
5,700
Rear wiper switch
OFF
9-16
?
LOW
910
HIGH
2,910

Inspection (With KDS/GDS)

1.

In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).

The diagnostic system(KDS/GDS) provides the following information.

(1)

Self diagnosis : Checking failure and code number (DTC)

(2)

Current data : Checking the system input/output data state

(3)

Actuation test : Checking the system operation condition

(4)

Additional function : Controlling other features including system option setting and zero point adjustment

2.

Select the 'Car model' and the 'Body Control Module (BCM)' to be checked in order to check the vehicle with the tester.

3.

Select the 'Current Data' menu to search the current state of the input/output data.

Rear Wiper Motor Repair procedures
Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect positive (+) battery cables to terminal 4 and negative ...

Rear Washer Motor Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water.    ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Special service tools
Special Service Tools Tool Name / Number IIIustration Description Ball joint remover 09568-34000 Used to remove the ball joint Strut spring compressor 09546-26000 ...

Kia Niro (DE HEV) Owners Manual: Charging System Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction with either the alternator or electrical charging system. If there is a malfunction with either th ...

© 2016-2025 www.kniro.net