Kia Niro: Body Side Molding / Rear Spoiler Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Body Side Molding / Rear Spoiler Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the tailgate upper trim. (Refer to Tailgate - "Tailgate Trim")

2.	Remove the anti-pinch strip. (Refer to Body Electrical System - "Anti-Pinch Strip")

3.	Disconnect the washer nozzle (A) and high mounted stop lamp connector (B).

Remove the cap (A) and then loosen the rear spoiler mounting nuts (A).

Tightening torque :

5.9 - 6.4 N·m (0.6 - 0.65 kgf·m, 4.3 - 4.7 lb·ft)

Remove the rear spoiler (A).

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Roof Rack Repair procedures

Replacement Put on gloves to protect your hands. ...

Fender Garnish Repair procedures

Replacement Put on gloves to protect your hands. ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Power Relay Assembly (PRA) Description and operation
Description The Power Relay Assembly (PRA) consists of the positive and negative main relays, pre-charge relay, pre-charge resistor and battery current sensor. It is located inside the battery pack assembly and controls the high voltage power circuit between the high voltage batte ...

Kia Niro 2017 (DE HEV) Service Manual: Parking Brake Cable Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the knee air bag. (Refer to Restrain ...